A dull master? What changed in Universal and Trap
When a master sounds duller than the original, the input level is not always to blame. We covered that in why a track sounds dull after mastering. This is a different angle: what we changed in the Universal and Trap styles, and how to check in a minute whether your own track lost its top.
What changed
The Universal and Trap styles now have more "air" and less dullness. The cause was the assistant's tonal correction: it could cut the top even on a track that did not need it. The correction now switches on only when a defect is found in the track.
We checked this on 159 tracks. The share of tracks whose air was cut by 1 dB or more fell from about half to about 10%. Loudness and peaks do not change: the change touches only the tonal correction.
Check your own track in three steps
- Open the "Spectrum before/after" chart. It shows where the master's tone differs from the original. Look at the air zone (labelled "Air 8–20k" in the app): if the master sits clearly below the original there, the top really was cut.
- Listen with the "Original / Master" player. Its loudness is matched, so the difference you hear is a difference in sound. Switch at the same spot in the track, without stopping the music.
- Loop the suspect part. Select a part and listen to it on repeat. Hi-hats, vocal breaths and sibilants show up best on a loop.
You can add a look at "Loudness over time". It shows whether the level is too flat through the song. Loudness and peaks are not part of this change, but a flat curve is another reason a track can feel closed.
If the top still feels closed
- Check the level of the source file. A source that is too hot makes the midrange dense and the sound dull. The order of checks is in why a track sounds dull after mastering.
- Try another variant. After the run, "Not right? Try differently" gives more top, louder or quieter. Before the run you can hear the variants in advance; see how to choose the mastering sound first.
- If the problem is harshness and not dullness, use "Soften harshness" instead of looking for air.
Worth remembering
The spectrum shows differences, but it does not say whether they are good or bad. Trust your ears at matched loudness, and use the chart to understand why it sounded that way.
Check your track in mastering: upload a file, master it and compare "Original / Master" on the brightest part.
Questions and answers
What changed in the Universal and Trap styles?
The assistant's tonal correction now switches on only when a defect is found in the track. Before, it could cut "air" where there was no need. Loudness and peaks do not change.
What was the change tested on?
On 159 tracks. The share of tracks with an air cut of 1 dB or more fell from about half to about 10%.
How do I check that a master did not turn duller than the original?
Open the "Spectrum before/after" chart and look at the air zone, then switch the "Original / Master" player: its loudness is matched, so you hear a difference in sound, not in level.
Upload a track — the same mastering engine, prices in euros.
Open Echoteka →AI mastering onlineLUFS analyzer